The Cricketer Tea Break Crossword
Crosswords7 mins ago
No best answer has yet been selected by NJOK. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.The plug in things are fuses, usually 5 amp white for lighting, 15 amp blue for immersion, 30 amp red for ring main, 45 amp green for cooker/shower. The fuse will blow if there is a fault in the circuit in your case this is the 5 amp lighting.
To isolate and identify any faultly light, switch off the main switch, rewire the fuse with the correct fuse wire (5amp), this is obtainable from hardware shops etc. on a cardboard reel with the different sizes, there may be some near the consumer unit.
Switch off all the lights, replace the fuse, switch on the main switch, Try each light in turn, hopefully this will turn out to be just a blown bulb but if the fuse blows on a particular light then there is a fault that will need dealing with. If this happens you can renew the fuse leaving the faulty light switched off until the fault is rectified.
This is quite an old system and although the fault is probably a short circuit in one of the light fittings,the safest way to check what is wrong is first of all make sure each light switch is in the OFF position repair the fuse with correct amperage fusewire 5 amp for lighting the wire threads through two little holes and tightens onto the little brass scews do not pull wire to tightly otherwise it will snap TURN OFF main switch replace fuse and turn on switch again then try each light in turn
if one of the lights blows the fuse again you will know what one it is ,it will go with a small bang you can then isolate the problem light, if the system is as old as it sounds the chances are that the earthing isn't going to up to current regulations, so I would advise you to have the whole lot checked in the near future anyway. GOOD LUCK