Quizzes & Puzzles1 min ago
cavity insulation
5 Answers
we were approached about having our house cavity walls insulated as they are not. My dad says people in the past have advised him to not have it done. We would love to have a more insulated house if there are no "side effects" anybody any experience to offer ?
Answers
Best Answer
No best answer has yet been selected by Thunderchild. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.I am not sure what happened in the past , perhaps they had problems with it.
I can remember an older friend saying, "the cavity is there for a purpose so don`t fill it in".
I can also remember a building society turning down mortgages that had this done.
I am sure this is not the case now, things move on. It will have been perfected by now, as in everything just avoid the cowboys.
Rodz
I can remember an older friend saying, "the cavity is there for a purpose so don`t fill it in".
I can also remember a building society turning down mortgages that had this done.
I am sure this is not the case now, things move on. It will have been perfected by now, as in everything just avoid the cowboys.
Rodz
The cavity was there for a purpose - primarily to prevent damp from penterating from the outer leaf to the inner leaf.
Injected cavity insulation forms into closed bubbles inside the cavity and, once set, the water cannot easily penetrate. Part of the mandatary pre-assessment used to involve the company (all of whom are pretty regulated these days) establishing the likely level of exposure of outside walls to driving rain and installation was not permitted if exposure was classed as severe. Not sure if this is still relevant. With injected foam a few isolated instances of formaldyhyde gas causing nausea have been reported. This is a byproduct of the setting process.
Other injection methods have tried blowing 'small 'beads' of insulation into the gaps. I have little knowledge of any such installations.
On balance, well worth doing for the cost versus savings.
Injected cavity insulation forms into closed bubbles inside the cavity and, once set, the water cannot easily penetrate. Part of the mandatary pre-assessment used to involve the company (all of whom are pretty regulated these days) establishing the likely level of exposure of outside walls to driving rain and installation was not permitted if exposure was classed as severe. Not sure if this is still relevant. With injected foam a few isolated instances of formaldyhyde gas causing nausea have been reported. This is a byproduct of the setting process.
Other injection methods have tried blowing 'small 'beads' of insulation into the gaps. I have little knowledge of any such installations.
On balance, well worth doing for the cost versus savings.