Crosswords1 min ago
What Determines How Quickly Cold Water Turns Hot When Running The Tap?
25 Answers
It takes 3 or 4 large bowls full since I had a new Bosch gas boiler installed. With my old boiler it was about 2.5 to 3. Nobody else I have asked in my block of flats has to wait as long. Is it controlled by a setting on the boiler?
Thanks.
Thanks.
Answers
Thanks ladybirder. From the manual for your boiler: "• Eco mode is an energy saving feature which disables the Preheat function. Eco is enabled by default, during the initial appliance start up and Eco is displayed. • Preheat mode, the hot water heat exchanger is kept pre-heated to reduce the time taken to deliver hot water at the tap. In the Preheat mode, if...
14:33 Fri 30th Jul 2021
Perhaps the pre-heat function, if available on your boiler, has not been turned on:
https:/ /idealh eating. com/ins tallers /suppor t/faqs/ boiler- control s/what- does-pr e-heat- mean
Can you give us the model number of your boiler?
https:/
Can you give us the model number of your boiler?
If it's one of the Worcester range of boilers (and possibly others) then the pre-heat function is controlled by the ECO button, according to this article:
https:/ /www.wo rcester -bosch. co.uk/s upport/ trouble shootin g/faqs/ all-faq s/why-m ight-i- want-to -progra mme-hot -water- times-w ith-my- combi-b oiler
https:/
Thanks ladybirder. From the manual for your boiler:
"• Eco mode is an energy saving feature which disables the Preheat
function. Eco is enabled by default, during the initial appliance start
up and Eco is displayed.
• Preheat mode, the hot water heat exchanger is kept pre-heated to
reduce the time taken to deliver hot water at the tap.
In the Preheat mode, if there has been no demand for hot water for 24
hours the appliance will save energy by suspending Preheat until there is
a demand for hot water. At this time Preheat mode is re-activated.
▶ Press the eco button (approximately 1 second) to manually switch
between eco [1] and preheat [2] modes.
Depending on which mode the appliance is in, pressing the eco
button (approximately 1 second) switches from one mode to the
other."
So, is your boiler in "Eco mode" at the moment?
"• Eco mode is an energy saving feature which disables the Preheat
function. Eco is enabled by default, during the initial appliance start
up and Eco is displayed.
• Preheat mode, the hot water heat exchanger is kept pre-heated to
reduce the time taken to deliver hot water at the tap.
In the Preheat mode, if there has been no demand for hot water for 24
hours the appliance will save energy by suspending Preheat until there is
a demand for hot water. At this time Preheat mode is re-activated.
▶ Press the eco button (approximately 1 second) to manually switch
between eco [1] and preheat [2] modes.
Depending on which mode the appliance is in, pressing the eco
button (approximately 1 second) switches from one mode to the
other."
So, is your boiler in "Eco mode" at the moment?
When you make that decision you are really deciding whether you want to waste water or gas. If you use your water infrequently, then keeping the pre-heat function on means you are keeping a small amount of water that you don't use constantly heated. As it cools the boiler will kick in and heat it up again. This goes on 24/7.
I have the facility on my boiler and I keep it switched off (especially in the summer when it takes less time to get to temperature). If I remember I switch it on before a few minutes before I need hot water but it really doesn't matter. I once accidentally left it on when I went away for a fortnight and it cost me a pretty penny to keep a hot water supply readily available.
When you make your decision bear in mind that water is considerably cheaper than gas and the water that you waste is unlikely to find its way to anybody needing it. As for the water companies bleating there is not enough of it about - there is, and plenty. It's their job to capture it and store it until required, for which they are paid handsomely.
I have the facility on my boiler and I keep it switched off (especially in the summer when it takes less time to get to temperature). If I remember I switch it on before a few minutes before I need hot water but it really doesn't matter. I once accidentally left it on when I went away for a fortnight and it cost me a pretty penny to keep a hot water supply readily available.
When you make your decision bear in mind that water is considerably cheaper than gas and the water that you waste is unlikely to find its way to anybody needing it. As for the water companies bleating there is not enough of it about - there is, and plenty. It's their job to capture it and store it until required, for which they are paid handsomely.
Thanks NJ, that's what I'm thinking about and I'm coming to your way of doing it. Might be cheaper to boil a kettle of water for washing dishes.
Bednobs thanks but have one bucket only and quite honestly I don't know what I would do with all that cold water.
Just had a brainwave ... Get my water from the Shower, it runs hot almost immediately;-))
Bednobs thanks but have one bucket only and quite honestly I don't know what I would do with all that cold water.
Just had a brainwave ... Get my water from the Shower, it runs hot almost immediately;-))
Related Questions
Sorry, we can't find any related questions. Try using the search bar at the top of the page to search for some keywords, or choose a topic and submit your own question.