It its got the digital display on the dash for the mileage you can put the dashboard into a test mode.
Put the key in the ignition but don't turn it.
Hold down the trip reset button
Start the car while still holding the trip reset and keep it held in for about 10 seconds until the display shows "test"
Then you can let go of the button, from then on each press of the button changes through different test modes... as below..
* 1.Shows a Gauge Sweep
* 2. Shows all 8's on the LCD (LCD TEST)
* 3. Illuminates all the bulbs on the dash
* 4. Displays hexadecimal value for ROM level
* 5. Displays the hexadecimal value for EE level
* 6. Shows DTC (Diagnostic Trouble Code)
* 7. Digital Speedometer - mph
* 8. Digital Speedometer - kph
* 9. N/A
* 10. Digital tachometer
* 11.Fuel volume
* 12. Engine coolant temperature
* 13. Battery voltage
* 14. ABS fail
* 15. Electronic brake distribution (EBD) failure
* 16. Illumination
* 17. Crank Sense
So press three will light up the fuel light to see if the bulb works.
(the above works on a lot of fords as well as the KA... the digital speedo in KPH is handy if you're aboard.)