Peugot 306 meridian diesel 1999T

[wickedtart19]

My battery went dead on my remote key, had the battery changed and will not operate to open/lock car. Had battery checked in shop all fine. One remote stil working and i have one normal key. The remot had two button one small to open the other larger to lock or it may b the other way around lol. Peugot say it does not need any code to operate, but there must be something that needs doing. Anyone help me please. many thanks

[__LEE__]

Obtain all keys fitted with remote
Remove key from one remote
Sit in drivers seat
Ensure doors are closed and unlocked
Insert 1 key into ignition switch
Turn switch to position 2 (dash lights on)
Point remote at receiver (near your rear view mirror)
Distance from receiver less that 10 cm
Press lock/unlock button or�.
���.Some models press lock/unlock button then double lock button (small button)
���.try both if unsure.
Repeat above procedure WITHIN 10 seconds for all other remotes
Confirm programming success by testing both buttons (and both remotes)

[wickedtart19]

i thought i pointed it at the front of the car as this is what i do when i open it wih the one remote working. Thanks

[wickedtart19]

hi lee

my remote has two buttons large large and one smaller one is for locking and the other unloicking the car, it also acts as a immboliser do i sill do what u ask. Also i have a lone key which i opresume i use once in the car, do i lock the cars with the one wroking remote or?? thanks

[wickedtart19]

well i tried what u said lee and it didnt work so i am going to goand get another battery for the remote tomorrow and c if that works. Any other ideas please. Thanks

[__LEE__]

if you only have 1 key you normally split the key and remote part of the key apart.

but if you have 2 keys you can use one to turn the ignition on, and with the other one (the one that needs coding) you can hold that next to the receiver .
Once ignition is turned on .. press large button then small button within 10 seconds.
That key will then recode.

[__LEE__]

make sure that when you turn your ignition on that you do turn it to position 2 on the switch.

[wickedtart19]

hi Lee

can i get this straight pls, i get in the car and lock all doors with the working remoe. Then i turn it twice til lights on dash are on. Then u say 10cm away from wherever it is activiation, sp do i cllimb into the back seat and press the key or!!!! sorry if this is a dumb question, but i am not at all technical, albeit a woman lol. Thanks

[__LEE__]

get in the car.. dont lock the doors.
do the above procedure

the receiver is very close to your rear view mirror.. in the roof
.. and stop thinking about climbing in the back seat
unless..... :)

[wickedtart19]

silly me i locked the doors, it is too late to try i now, will try again in the morning, thank you for putting up with a silly woman.lol

[wickedtart19]

hi Lee, well i tried it and it didnt work, so went and have the new battery tested but it was fine, they told me it is probably the circuit board inside, and since it going to cost approx �150 i thoughti would leave it. But thank you so much for all your help. Your help was greatly appreciated. Thanks again

[__LEE__]

your welcome