Donate SIGN UP

floppy not working

Avatar Image
pyritechips | 03:56 Thu 13th Jun 2002 | Technology
7 Answers
I had to unplug my floppy to work on my cd-rw but when i plugged it back in, it wont work and im getting an error msg: 2f8h com address conflict> Any ideas people? Im baffled ~Jim
Gravatar

Answers

1 to 7 of 7rss feed

Best Answer

No best answer has yet been selected by pyritechips. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.
Have you gone to The device manager. To look at which device may be conflicting with each other ? 2f8h is supposed to be reserved for com2 (normally) The plugs on floppies can some times. Be plugged in backwards. If the floppy light is continuosly on reverse the plug. Other than what I have stated. I would add only. Tho check all wire plugs and connections. You may have bumped someting loose. Good Luck
Geesh look at the typos.. :)
Question Author
Thx Astron but i have done a complete physical check and a BIOS check and all is well there. I even pluged the drive into my mom's computer and it works ok. One tech site said to go into system device manager and remove it then windows will recognize and reiinstall it and driver on reboot but that hasnt helped either. I'm at a total loss! ~Jim
There is one basic rule when working on a PC, if you do something and find that something else doesn't work, return it to the state it was when everything was ok and start again. Regarding the fdd, make sure both ends of the data cable are in correctly, if necessary, take the drive out of the case and try it, when it works, put it back.
Question Author
Thx to you Mattie but I've tried that> I've tried every concieveable arrangement with no positive result. System manager says the drive is there, BIOS says its there but if you click on A: or try to access a disc, the computer locks up so bad I have to use power button to start over. ~Jim
In that case go back a bit, make sure the data and power cables are correctly connected, no bent or broken pins on the back of the floppy drive. Go into the bios and switch on boot up floppy seek, if you hear the drive motor when you reboot then go from there, if not then try another drive.
Question Author
Thx to all you ppl that tried to help but ive been the victim of a intermittant floppy drive failure. First I put it in my mom's comp and it worked so i assumed the prob was in my comp. After a week of fiddling and cursing i put my mom's floppy into my comp and it worked fine! Grrr! Put mine back in hers and NOW it doesnt work! Oh well! Thx again anyways ppl! ~Jim

1 to 7 of 7rss feed

Do you know the answer?

floppy not working

Answer Question >>