Crosswords1 min ago
Ford Fiesta Warning Lights
There are 2 warning lights luminated in the dash of my S reg ford fiesta. One is ABS and the other looks like a skidding tyre or something similar, I have checked the handbook but it does not show this symbol, can anyone advise whats wrong - thanks
Answers
Best Answer
No best answer has yet been selected by shearwen. Once a best answer has been selected, it will be shown here.
For more on marking an answer as the "Best Answer", please visit our FAQ.Hi just had the fault with my 1999 Fiesta (Mk 4)
The most common fault is due to the ABS sensor on the drivers side front failing, its easy to check, unplug the 2 pin connector and test with an ohm meter you should have a circuit i think about 1K but dont worry, just check you have a circuit. mine was open circuit, replaced with one off Ebay for �35 job done! Oh one more thing, this threw me for a bit, once you have done it the ABS light will still be on, so drive your car above 30 mph and it should reset!
A bit more technical info if you still have problems, obviously check all the other 3 sensors for the same fault.
switch your test meter to mV and connect to the sensor and spin the wheel you should see a slight reading, one other check, turn on the ignition and check the incoming supply to the sensor, this should be about 2.5v
Happy motoring
The most common fault is due to the ABS sensor on the drivers side front failing, its easy to check, unplug the 2 pin connector and test with an ohm meter you should have a circuit i think about 1K but dont worry, just check you have a circuit. mine was open circuit, replaced with one off Ebay for �35 job done! Oh one more thing, this threw me for a bit, once you have done it the ABS light will still be on, so drive your car above 30 mph and it should reset!
A bit more technical info if you still have problems, obviously check all the other 3 sensors for the same fault.
switch your test meter to mV and connect to the sensor and spin the wheel you should see a slight reading, one other check, turn on the ignition and check the incoming supply to the sensor, this should be about 2.5v
Happy motoring