Haier 1000 Tx Ve Washing Machine

[gulliver1]

My Haier washing machine won't drain, as anyone got any suggestions, It has stopped with the water still inside, I have tried drain only and spin only but it just keeps going round with the water still inside.
Many thanks

[paddiez]

Outlet pipe is probably blocked. Not an east one to correct.you need to take the back off the machine,find where the pipe goes ,take it off and manually clear the blockage.

[Hymie]

I would hazard a guess that you have one of three faults on the machine:-

1) The drain pump motor is broke
2) The machine control board is broke
3) The filter is blocked

Numbers 1 & 2 will require an engineer in attendance.
Number 3 will require you to remove the filter – normally located somewhere on the front of the machine, close to the floor. If you are lucky, there will be a small tube besides the filter to allow you to drain the water before you pull the filter. Pulling the filter will result in lots of water all over the floor.

[Hymie]

Of course, I should have added that once removed – you will need to clean the filter and refit. I recently suffered the same problem, caused by a colour catcher cloth finding its way into the filter.

Paddiez may also be correct, in that your outlet pipe is blocked.

[Fitzer]

Check the simplest first, if the outlet hose plumbs into a fitting on a sink trap these can block up pretty easily (at least mine does!), try checking that before dismantling the machine.