asrock k8 upgrade vm800 main board not booting

yellowjohn | 22:00 Sun 05th Mar 2006 | Technology

4 Answers

i installed an asrock k8 upgrade vm800 main board to replace my socket a board but it will not boot.in the bios my pc3200 400mhz memory ( 1.5 gb) shows as 133mhz and this is the only prob i can see as the cpu shows corectly.do i need to install the board drivers first or should xp load generic ones ok as they have in the past.or do i need to format before installing as it is a different type of board.any ideas please...cheers.

Archos AV500

Powerpoint slide show

Answers

1 to 4 of 4

Best Answer

No best answer has yet been selected by yellowjohn. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.

b0shb4ll

do you get any morse code likes noises? At which stage of boot up does it get stuck at..

yellowjohn

Question Author

it just gets to the screen that gives you the option to start in safe mode or the last configuration that worked.there are no beeps from the pc.

Timm

Is your XP install clean or did you just plug the Hard Drive straight on to the new board?

I suspect you need to do a Repair on it so XP can reconfigure with the new hardware.

For help with this please look here.
http://www.michaelstevenstech.com/XPrepairinstall.htm

b0shb4ll

I would agree with Timm on this. If you simply plugged it in without updated drivers xp can sometimes correct itself but most of the time it fails...

1 to 4 of 4

Do you know the answer?