Donate SIGN UP

Thermostat

Avatar Image
bazwillrun | 17:22 Sat 12th Jan 2013 | Home & Garden
6 Answers
Need to get an indoor thermostat for the central heating.

current one is a very basic honeywell with just a manual dial on the front.
It has two wires blue and brown, earth isnt connected

All I want to do is to be able to set the differential, so theres a smaller temp drop between reaching set temp, going off and kicking back in a gain.

Dont need any fancy timers facilities etc, and if its digital preferably not a green display.

had a look around but the ones I've looked at dont make it clear if differential can be set, if they do its not in plain english I can understand
Any suggestions
Gravatar

Answers

1 to 6 of 6rss feed

Best Answer

No best answer has yet been selected by bazwillrun. Once a best answer has been selected, it will be shown here.

For more on marking an answer as the "Best Answer", please visit our FAQ.
Did you look at this one, Baz?
http://www.honeywelluk.com/products/Temperature-Controls/Temperature-TPI-Control/DT90E/

Do you need help understanding how TPI works?
Question Author
HI did actually, Honeywell was the first site I visited but a lot of what it says and does means nothing.
I just want to set a temp say of 20 and then say 19 for when it comes back on
so a 1 degree C differential in this case, plain and simple, not bothered about timers etc.

At the moment Mrs Baz is the most accurate thermostat in the house ! soon as it hits temp turns off and starts dropping she notices it, have to say it does seem to get a tad chilly before it kicks back in again.

surely there must be a thermostat where you can set the differential in say half/whole degree increments
Question Author
Just had a look at the online manual
1. Set Temp...so far so good
2. Temp inquiry ????....given up already...what does that mean ?

does do what I want it to do, the plain and simple way ?
Baz..I assume you have an old 230v stat with as you describe 2 wires.These will be feed and return wires..both can be live.To swap for a new 230v stat and to achieve a small differential you may need a neutral conductor and certainly an earth.With newer boilers the stat is generally at extra low voltage and only requires a 2 wire system.
Question Author
Couldnt tell you, but what i do know is that there is an earth wire inside the stat but its not connected to anything

boiler is a combi about 12/13 years old and will churn out 80,000BTU
Question Author
Sounds like its just easier to turn the temp up to start with

1 to 6 of 6rss feed

Do you know the answer?

Thermostat

Answer Question >>