Dc07

[col72]

Dyson dc07 hardly picks up at the bottom has great suction at the wand cleared all the tubes and filters out no rips in the little pipe brush turns fine

[Gizmonster]

You say you've cleared all the pipes etc, but it def sounds like a blockage.
It's a while since I've messed with a Dyson, but if you turn it upside down, so you expose the brushes, etc, I'm sure there are some screws holding the bottom plate on. Take all the screws out and it'll give you further access to a few more pipes that lead down to the brushes. You'll prob find that there's a big ball of fluff/hair clooging one of the pipes up.

[boxtops]

I got rid of my Dyson in the end, so I can't offer current advice - but yes, there's probably something stuck in the bottom of the machine.

[alavahalf]

A common problem is the drive belt stretch's and you loose the rotation of the brush bar under load. The only answer is to replace the belt. It's an easy job to remove the plate.
Another possible problem is the rubber flap under the wand tube ... it often hangs down a little bit, either it could be partially open due to a bit of rubbish being jammed in it, or they also droop a bit with age. This will also cause a loss of suction.
The same thing happened to ours, so I removed it and turned it upside down.
Problem solved..!

[chas2008]

have a had a dyson DC07 for years the one thing i like about is how easy it is to remove or unclip all the various pipes/filter etc.to remove any blockages.

[col72]

another thing the filter on the side when you take it off the hoover i cant separate it from the houstng

[alavahalf]

Sounds like you may have found your answer , possibly a blocked filter... the housing just unclips and you should be left with two halves of the carrier.