Donate SIGN UP

DIY

1561 to 1580 of 1665

First Previous 76 77 78 79 80 81 82 Next Last

Avatar Image
stanwilcock
With a clay tile roof, what is the maximum span of a rafter on a 35 degree pitch using 150 x 50 c16 graded timber between pick up points, ie wall plate and purlin/ridge? Thanks.
Avatar Image
hev
Need some advice our concrete gutters have sprung a leak we cannot afford the option of removing them so has anyone had the same trouble and is there any particular sealing products that you have used...
Avatar Image
philblack
Hi all, what is the plumb cut angle of a valley rafter when the pitch of the roof is 35 degrees and is there a formula to work this out on any size pitch? Thanks
Avatar Image
greenrook
I want to remove some ancient storage heaters and replace them with new panel heaters. Can I ask an electrician to use the existing wiring to supply juice to them, and rejig the connection from the...
Avatar Image
123everton
Can anyone find the fitting instructions for a Garador Salisbury 7066c door with Georgian bars? I think it's classed as a retractible door. I've tried their website to no avail? Thanks....
Avatar Image
Akinator
I have decided to undertake a bit of DIY. I have purchased some decking but I am not sure at what distance I should put the joists apart. Would 600mm be about right?
Avatar Image
Finwoodhill
I need to rebate the edge of some 3" x 2" timber to make a gate. What is the best/most cost effective tool to achieve this?
Avatar Image
codswallop
I have an Indesit washing m/c.until,recently it did the wash part of the cycle but won't progress to the rinse and pumping out unless I change the dial by hand and then it carries on .Does anyone...
Avatar Image
des1
I have a manual power shower that works fine but when i turn it off it continues to drip. Any ideas please?
Avatar Image
rocbert
need to replace fascia boards around garage and walkway, and will require approx 30 m of board. What is the typical price of fascia boarding, and what is a reasonable price to pay to get the job done...
Avatar Image
SusieWinwood
We've just got a stable door for the side door and need to put a cat flap in. This is the style http://www.wickes.co....ble-Door/invt/205785. With it not being a solid door would this cause problems?...
Avatar Image
zita-green
Is there a way of removing iron oxide deposit from inside an old glass bottle?
Avatar Image
2gbmum
My external tap in back garden has lost all pressure. Hadn't used it over the winter and then came to use it recently and found a weak dribble coming out. Tried over next weeks and it's the same. It...
Avatar Image
lynbeast
I have a Potterton Suprima 40L about 6 yr old. Had no problems with it over the past years. I have no central heating to the radiators for the past 2 weeks downstairs, the radiators work upstairs...
Avatar Image
lynbeast
I have a Potterton Suprima 40L about 6 yr old. Had no problems with it over the past years. I have no central heating to the radiators for the past 2 weeks downstairs, the radiators work upstairs...
Avatar Image
jacklee
Where can I buy table mats with Jack Vettriano pictures?
Avatar Image
fd1972uk
Hi, Could anyone advise if I can paint this type of furniture? The material type is below. Also wondering if anyone can advise if I require a special type of paint? Ta Basematerial: Particleboard,...
Avatar Image
Ifor
I want to match interior doors (standard size, single) that have a 4 to 6 inch frame all round and a single panel of glass (toughened Flemish) as insert. The glass isn't a problem, but none of the DIY...
Avatar Image
hope19
I am trying to find a varnish suitable for stone work..any suggestions please.
Avatar Image
zita-green
Can anyone suggest how best to repair potholes on drives?

1561 to 1580 of 1665

First Previous 76 77 78 79 80 81 82 Next Last